3 posts / 0 new
Last post
millmeister's picture
Offline
Last seen: 1 month 5 days ago
Joined: 29/07/2014 - 15:59
Posts: 2
Running a 'shot gun' style cable around corners

I'm considering the Van Damme 2.5mm LCOFC speaker cable that has been much praised about on this forum. The only problem is that I need to route it around a door frame. The cable doesn't need to fit around the frame at a rigid 90 degrees necessarily but I'm wondering how flexibile it is given that it's a 'shot gun' design. Is it possible to cut the cable into two separate lengths?

Any input welcome, thanks.

michael hoy's picture
Offline
Last seen: 2 days 15 hours ago
Joined: 06/10/2008 - 18:56
Posts: 1604
millmeister wrote:

millmeister wrote:

I'm considering the Van Damme 2.5mm LCOFC speaker cable that has been much praised about on this forum. The only problem is that I need to route it around a door frame. The cable doesn't need to fit around the frame at a rigid 90 degrees necessarily but I'm wondering how flexibile it is given that it's a 'shot gun' design. Is it possible to cut the cable into two separate lengths?

Any input welcome, thanks.

Yes you can split the cable by running a knife down the middle of the two cables.

 

millmeister's picture
Offline
Last seen: 1 month 5 days ago
Joined: 29/07/2014 - 15:59
Posts: 2
Thanks for your input - will

Thanks for your input - will give it a go.

Log in or register to post comments